Datecs DPP-450 Manual de usuario Pagina 7
- Pagina / 38
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
DATECS DPP-450 Programmer’s Manual
Press longer than 1 sec.: Feed paper to find next black mark.
(Same as sending FF command)
- Remarks for programming
As it is possible to print on black mark, if user does not want to print on the black mark, it have to be
taken care by user side program
- Remarks on handling
If the paper cover is open in black mark mode, there is a possibility to recognize it as detecting black
mark.
5. The operation of the command depends on the state of the configuration flags 2, 3 and 4 (CR)
Code: [0Dh]
This command is ignored or its action is the same as LF depending on the state of memory switches
2, 3 and 4, set using last command GS ).
6. Image LSB/MSB select (DC2 =)
Code: [12h] + [3Dh] + n
The command selects whether the left edge of print image is the LSB or MSB for commands GS *,
DC3
F and DC3 v. n is from 0 to FFh, but only least significant bit checked:
0: LSB is the left edge.
1: MSB is the left edge.
Default is 1.
7. DC3 (Ruled line) commands sequence start (DC3 ( )
Code: [13h] + [28h]
Following this command the printer receives DC3 commands without DC3 symbol at the beginning.
The symbol ‘)’ ends the sequence. All commands, which are not DC3 commands, are ignored.
8. Sets the ruled line ON (DC3 +)
Code: [13h] + [2Bh]
After receiving this command every printed line is combined with the selected ruled line buffer. This
happens when commands LF, ESC J, ESC d, DC3 P, DC3 p are executed. Depending on last command
DC3 M executed the ruled line buffer is combined with the text using OR (if there is a bit ‘1’ in ruled
line buffer, a black dot is printed) or XOR (if there is a bit ‘1’ in ruled line buffer, then the
corresponding dot is inverted).
All DC3 command except DC3 P and DC3 p are executed when ruled line mode is off, too. Su the
ruled line buffers can be cleared or set before this command.
The command DC3 – sets ruled lines off.
In page mode nothing is printed outside the selected using ESC W region.
The command does not clear rule line buffers.
By default ruled lines are disabled.
9. Sets the ruled line OFF (DC3 -)
Code: [13h] + [2Dh]
The command disables ruled line mode.
All DC3 command except DC3 P and DC3 p are executed when ruled line mode is off, too. Su the
ruled line buffers can be cleared or set after this command.
The command DC3 + sets ruled lines on.
The command does not clear rule line buffers.
By default ruled lines are disabled.
Relacionado con productos y manuales para Impresión y escaneo Datecs DPP-450
Impresión y escaneo Datecs EP-2000 Manual de usuario
(65 paginas)
(65 paginas)
Impresión y escaneo Datecs LP-50 Manual de usuario
(25 paginas)
(25 paginas)
Impresión y escaneo Datecs DPP-450 Manual de usuario
(29 paginas)
(29 paginas)
(4 paginas)MD Building Products 70094 manuals
Owner’s manuals and user’s guides for Unknown MD Building Products 70094.
We providing 1 pdf manuals MD Building Products 70094 for download free by document types: Installation Guide
Comentarios a estos manuales