DATECS DPP-450 Programmer’s Manual
been skipped by the horizontal tab. Neither is it attached to 90°-right-turned characters.
The underline width is as having been specified by (FS -). (The default setting is 1 dot width.)
If at the same time are given double height and/or double width and 90°-right-turning of character,
then
the sequence of execution is as follows:
- character is doubled in the direction indicated
- character is turned at 90°-right-angle
107. Selecting the two-byte text mode - JIS or GB2312 (FS &)
Code:
[1Ch] + [26h]
The command selects two-byte characters mode. Depending on the version of the printer, this may
be:
- Japanese version: JIS character table. First byte is between 20h and 7Fh, second byte between 00h
and 7Fh. If outside this range, one-byte ASCII characters are printed.
- Chinese version: GB2312 (Simplified Chinese). First and second bytes are between A0h and FFh. If
outside this range, one-byte ASCII characters are printed.
108. Selecting/Cancelling underline for two-byte text mode (FS -)
Code: [1Ch] + [2Dh] + n
An underline is attached to the full character width. It is, however, not attached to the part
having been skipped by horizontal tab command.
An underline is not attached to 90°- right-turned
characters. The following values of n are possible:
0 or 30h Canceling an underline.
1 or 31h Specifying an underline of 1-dot
width. 2 or 32h Specifying an underline of
2-dots width.
109. Cancelling the two-byte text mode (FS .)
Code: [1Ch] + [2Eh]
The command cancels two-byte characters mode (JIS or GB2312 depending on the version).
For Japanese version only: If Shift-JIS character mode was selected before using FS C command, then
the printer returns to Shift-JIS mode instead to one byte ASCII text mode.
110. Selecting Shift-JIS mode (Japanese version only) (FS C)
Code: [1Ch] + [43h] + n
The following values of n are possible:
0 or 30h Canceling two-byte Shift-
JIS mode. 1 or 31h Specifying two-
byte Shift-JIS mode.
The command selects/cancels two-byte characters mode Shift-JIS. It is supported only in Japanese
version of the printer. First byte is between 80h and 9Fh or between E0h and FFh, second byte
between 40h and FFh. If outside this range, one-byte ASCII characters are printed.
If both JIS and Shift-JIS modes are selected, the Shift-JIS mode is active.
111. Specifying character spacing for two-byte text mode (FS S)
(65 paginas)
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales