Datecs EP-2000 Manual de usuario descargar pdf (Pagina 14)

1 DATECS

OD 07.01.02/v.1

стр. 14 от 65

EP_2000_PM_EN_V.1.60_Nov.2009.doc

7. (DC3 ( ) DC3 (Ruled line) commands sequence start

Code

[13h] + [28h]

Description Following this command the printer receives

DC3

commands without

DC3 symbol at the beginning.

The symbol ‘

)

’ ends the sequence.

All commands, which are not

DC3

commands, are ignored.

The command is supported in firmware

version 1.51

or higher.

8. (DC3 +) Sets the ruled line ON

Code

[13h] + [2Bh]

Description After receiving this command every printed line is combined with the

selected ruled line buffer. This happens when commands

ESC J

ESC d

DC3 P

DC3 p

are executed.

Depending on last command

DC3 M

executed the ruled line buffer is

combined with the text using OR (if there is a bit ‘

’ in ruled line buffer, a

black dot is printed) or XOR (if there is a bit ‘

’ in ruled line buffer, then

the corresponding dot is inverted).

All

DC3

command except

DC3 P

and

DC3 p

are executed when ruled

line mode is off, too. Su the ruled line buffers can be cleared or set

before this command.

The command

DC3

– sets ruled lines

In page mode nothing is printed outside the selected using

ESC W

area.

The command does not clear rule line buffers.

defaul

t ruled lines are

disabled

The command is supported in firmware

version 1.51

or higher.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

Comentarios a estos manuales

Sin comentarios

Datecs EP-2000 Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Datecs EP-2000