Datecs EP-2000 Manual de usuario descargar pdf (Pagina 46)

1 DATECS

OD 07.01.02/v.1

стр. 46 от 65

EP_2000_PM_EN_V.1.60_Nov.2009.doc

74. (GS FF) Printing in page mode and returning to standard mode

Code

[1Dh] + [0Ch]

Description The command prints the image in the currently defined page and leaves

page mode.

All the page memory is erased.

The command is supported in firmware

version 1.51

or higher.

75. (GS $) Specifying the absolute vertical position in page mode

Code

[1Dh] + [24h] + nL + nH

Description

Lower byte of the new vertical position

Higher byte of the new vertical position

The command sets new vertical print position. If the position is outside

the currently active page, the command is not accepted. The real new

coordinates depend on the print direction (selected using

GS T

The command is invalid in standard mode.

The horizontal position is changed with commands

ESC $

and

ESC \

–

they work both in page and standard mode.

The command is supported in firmware

version 1.51

or higher.

76. (GS )) Setting printer flags (memory switches)

Code

[1Dh] + [29h] + f1 + f2 + … + f13

Description This model has 13 memory switches and selecting, releasing, and

changing a function is available with this command. With this command

can be set 13 flags (memory switches), they are switched ON or OFF.

Memory switch setting is retained even after printer power off. These

flags are like virtual switches defining the state of the printer.

is the flag that we want to switch ON or OFF.

All flags must be set.

Possible values are:

‘0’

Flag is OFF.

‘1’

Flag is ON.

‘.’

Flag stays unchanged.

Meaning of different flags:

Flag

OFF ON

Power on/off sound disabled Power on/off sound enabled

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 64 65

Comentarios a estos manuales

Sin comentarios

Datecs EP-2000 Manual de usuario Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Datecs EP-2000